Picture & Frame Hanging
Command Strips - Value Pack
Holds Strongly | Removes Cleanly | No surface damage
Command Wire-Backed Picture Hanging Hangers For Wire Backed Picture Frames.
- No Nail holes
- 3 hangers (each hangers holds 5lb)
- 6 large strips
Hangers can be reused with Command Adhesive Large Strips.
Limited Warranty: This 3M product will be free from defects in material ad manufacture. If this product is defective, your exclusive remedy shall be, at 3M's option, replacement of the product or refund of the purchase price.
Limitation of Liability: 3M will not be liable for any loss or damage arising from this product, whether direct, indirect, special, incidental or consequential.
Save instructions for clean removal in the future or visit commandstrips.com
Important! Follow instructions carefully!
- Clean surface. Use isopropyl rubbing alcohol, wipe lightly, let dry. Do Not use household cleaners.
- Apply strip. Remove red Command Adhesive liner. Align square end with raised line on back of hook. Press Firmly.
- Press Firmly! Remove black "wall slide" liner. Position hook and press entire hanger firmly for 30 seconds.
- Wait 1 hour before use.
- Grab Removal Tab to prevent hook from snapping your fingers, hold hook as shown, Do Not press hook against wall.
- Slowly slide the tab straight down against the wall stretching the strip at least 15 inches (38cm) until hook releases from the wall. Never pull the strip out at an angle. Strip could break or damage the surface.
Note: Apply to surfaces above 50°F (10°C). Adhesive could soften and lose adhesion above 105°F(40°C)