Recapit Dental Repair Cement for Loose Caps

The best dental repair material available. The product is a unique, no-mix cement made especially for replacing loose caps and crowns. Clinically tested and guaranteed, it is safe and so effective "you can eat on it."

• 8+ repairs
• Maximum hold
• Instant pain reliever
• No mixing, no waste
• Resealable
• Eugenol free
• Dentist recommended

1. Wash hands and dry thoroughly.
2. Prepare crown by carefully removing as much old cement as possible from the inside of the crown.  Rinse and dry well. 
3. Carefully clean and rinse tooth are with water.  Do not dry.  Leave moist.
4. Try to fit the crown back on the tooth before applying Recapit® cement.  Make sure it fits properly.  If you cannot do this, Do Not Proceed.  See your dentist.
5. Make sure inside of crown is dry.  Use applicator brush to remove a small amount of material from multi-use vial.  Paint a layer of material on the upper inside edge of the dry crown. 
6. Remoisten tooth area, place crown on wet tooth and press firmly.
7. Bite down several times to insure proper fit.  If the bite is not completely comfortable remove and repeat all steps until the crown feels normal.
8. Wait 5 Minutes And Then Gently Remove Any Excess Material.  Rinse Out Mouth Well With Water.
9. Allow at least 1 hour to set before eating.  Cement will fully set in 1 to 3 hours.
10. Clean brush thoroughly by rinsing in warm water and wiping with a paper towel or tissue.
11. Keep vial closed to maintain freshness of remaining material.  Note: When replacing a bridge apply Recapit® sparingly to only 1 hollow tooth at each end of the bridge.  Recapit® should not be used on implants or posts without dentists advice.  Any leftover material may be re-used as long as it remains soft and pliable.  One the material hardens it is no longer useable and must be discarded.

©2007 Majestic Drug Co., Inc.